Introduction
We built these replacement heating lamps for one reason: to fit your Sidel blow-molding machines like a glove. From the older SBO models to the brand-new Matrix series, they slip right in. No modifications. No messing around. Just a clean, drop-in swap that brings the heat back to the way your machine was meant to run.
The Power Behind the Heat
Here’s the thing—Sidel machines need a lot of heat, packed into a small space. So we packed 2,500 watts into a 300mm tube. That gives you the punch to warm up the preform neck and body fast. And it’s all matched to the machine’s 400V power. So the lamp can pull full load without any current-limiting tricks. The result? Consistent cycle times, with no heat lag between shots.
What’s Inside That Makes It Work
Inside, you’ve got a halogen capsule that delivers steady infrared heat, with tight control on the filament temperature. The quartz envelope handles the constant on-off cycling without getting cloudy over time. A reflective coating on the inside pushes the heat forward, so you’re not wasting energy on the machine frame or wiring. And the R7s connector? That’s the anchor. It holds the lamp in length, keeps solid contact, and handles the high current without extra crimps or adapters. That’s why it’s a true direct swap—no rewiring, no brackets, no hassle.
What It Feels Like on the Floor
On the shop floor, this is all about keeping things running smooth. You get consistent heating across every Sidel model, which makes life easier on spares. One lamp spec covers it all. Installation is fast. Line up the R7s ends, seat the lamp, and lock it down. No cutting, no custom mounts. Now, a heads-up—2,500 watts puts out serious heat. So you’ve got to keep the machine’s cooling and airflow in good shape. Keep those going, and the lamp runs predictably shift after shift. Fewer burnouts. Less downtime. Just steady, reliable blowing.