Medium Wave Halogen Heat Lamp 560mm 220v 1500w

July 22, 2026

Let’s talk about the 560mm 1500W Halogen Lamp

If you’re dealing with a process that needs a deep, steady soak of heat—not just a quick surface sear—this is the lamp you want. We built this one to run at 220V and 1500W, which gives you plenty of punch without taking up too much room in your heating banks. Why medium-wave actually matters Here’s the thing: this isn’t a flash lamp. Because it uses medium-wave IR, the heat actually sinks into your material. It doesn’t just sit on top. That’s a huge deal if you’re working with materials that scorch easily. You get a nice, even warmth throughout the piece instead of those nasty hot spots that ruin a batch. The secret sauce inside the glass Inside that quartz tube, we’ve got a halogen cycle going on. Basically, as the tungsten filament starts to wear down, the halogen gas pushes that tungsten right back onto the wire. It’s a clever little loop. It keeps the filament from thinning out too fast, so your light output stays steady for a lot longer. Plus, you can plug this straight into most 220V setups. No need to mess around with bulky transformers. A few things to watch out for This is a great drop-in for PET blowing or drying lines, but it’s powerful. Like, really powerful. Since it’s pulling 1500W, it gets hot. Not just the target material, but the housing too. You’ve got to make sure your cooling fans are actually doing their job. If your airflow is weak, you’re going to melt your sockets or burn out the ends of the tube. It’s a headache you don’t want. One last tip: check your controllers. These lamps can have a bit of a surge when they first kick on from a cold start. I’d suggest using an SCR power controller. It lets you dial in the temperature exactly, which is a lifesaver when you’re switching between different material thicknesses.